I have designed a few of my own bears and one of the problems that I always have is the footpad. I have been very very lucky that I have no special formula for the right size footpad but they have always seemed to fit.:D
However I would like to have a formula so that I can always get the right size. Is there a special way of doing this.
I also want to make a bear with BIG feet and can't even imagine how to go about getting the footpad the right size.
I have no idea whether there is a formula but I use the ol' "cut a piece of string to fit" method, which works well for me.
Begin with your leg pattern piece.
Cut a piece of string -- I use crochet thread, which is about 1mm thick, because it's easy to work with -- to match the length of the bottom edge of your leg pattern piece. That piece of cut thread will be equal to HALF of your footpad outline.
From here, it kinda depends on whether you want your footpad to be perfectly symmetrical all the way around (easiest), or whether you want to make it wider at the top, or curved at the insole, etc. But whichever you choose, in the end, all you've gotta do is make sure that the footpad you draw has an outline equal to twice the length of your thread.
You could, I suppose, also just DOUBLE the length of the thread you cut, after you measure against the bottom of the leg pattern piece. However, I find it easier to work with half.
When I'm making a SYMMETRICAL footpad (like an oval shape, or a football shape, or a rounded-edge-rectangular shape), I:
1) Measure and cut a piece of thread to match the bottom edge of the leg pattern piece
2) Take a piece of paper and fold it in half
3) Lay that cut thread in an arc on my folded paper, with its ends touching the fold line.
4) Carefully trace around the thread edge
5) Cut thru the double thicknesses of paper while the paper is still folded
6) Open the footpad
7) Admire my handiwork... or adjust and retrace if it's too skinny/pointy/fat/circular/whatever.
To make a symmetrical footpad even more symmetrical, you can fold the paper instead into FOURTHS. In that case, you have to cut your thread IN HALF first, to get the right measurement. This is more complicated to explain in words and without illustration but mathematically it's the same idea. You'll get precise symmetry across all four "corners" of your footpad using this method, but if you can't figure out what I'm saying, try the method above first... and then I think it will become very clear.
I find that the easiest way to design foot pads of various sizes and shapes is to first draw the leg pattern. Take some fine but firm wire (you can get small rolls of wire at the hardware, just make sure it is easily bent but will hold shapes) and cut a length of it equal to double the length of the foot pad + 1/2". Fold the wire in half and join it, using quarter inch tails. You should not be able to bend the wore oval into the shape you want. This works well, especially for large pads that you may want narrow at the heel and very wide at the toe. Trace around the shape on your pattern paper. Take up the wire and adjust the edges.
You might want to check out this thread I started on Edinburgh's site.
I too, wanted to make big feet and there were quite a few wonderful ideas sent to me.
So make a tall glass of iced tea and sit back and enjoy! :D
Shantell...I don't remember any photos actually being posted. I think one of the ladies sent pictures around to those who wanted a better idea of it.
Thank you for your comment on the pups. My maltese never met reserve...bummer! I don't think that maltese bring the money that the yorkies do...but such a beautiful breed!